Keeway superlight 125 ler gas

Dakle,

poslao sam mail kinezima u keeway sa molbom da mi dostave uputstva za superlight i još isti dan su mi poslali detaljna upustva na 83 strane u PDF-u.Uputstva sadrže apsolutno sve i ako bilo tko treba nek mi je javi na PM i vrlo rado ću mu poslat.
Zanima me samo dali bi mi netko mogao prevesti dio za štelanje karba jer nikak da si to smisleno prevedem.
Hvala

"STEPS FOR ADJUSTING CARBURETOR

Install carburetor in engine, and then adjust it as the following steps:

1 Start and warm up engine for about three seconds so that engine rotates at normal driving temperature;
2 Adjust idle speed adjusting screw so that engine rotates at 1400rpm
3 Screw mixture ratio adjusting screw into bottom, the strength is not too weight

4 Now engine shuts off (if it doesn’t shut off, inspect if gas leaks out of the joint of air cleaner and if screw is
tight, inspect if the inlet port of air cleaner is blocked)
5 Screw mixture ratio adjusting screw back for one round
6 Restart engine, adjust idle speed adjusting screw to be 2000-2500rpm
7 Slowly adjust mixture ratio screw anticlockwise until engine rotates at the highest speed screw mixture
ratio screw back for less than 3 rounds

8 Readjust idle speed adjusting screw so that engine rotates at 1400±100rpm
9 Play throttle to accelerate rotating, inspect if its rotating speed is stable
10measure exhaust and compare it to standard volume.

NOTICE


1 Adjust mixture ratio screw properly not too tight, never energize too much, otherwise it may damage
mixture ratio screw head even break the adjusting screw

2 If engine is adjusted to be too slow rotating speed, engine may be off, in reverse, engine may consume too
much fuel.

WARNING

After engine rotates normally at idle speed for some time, turn throttle completely, then loose throttle
handlebar completely, at this time if idle speed changes, it means that throttle cable has not been adjusted well.
So before measure engine, pay special attention to corresponding adjustment."